Why does my electric keep tripping?

By Liam, OHMS GROUP LTD ·

When the power goes off and you find a switch down in the consumer unit, the board is doing its job: it has detected a problem and disconnected the circuit. Most trips are caused by a faulty appliance, and a few simple checks will usually find it. Repeated tripping with nothing plugged in points to a fault in the wiring, which needs an electrician.

Which switch has tripped

Open the consumer unit cover and look at which device is down.

  • A circuit breaker, also called an MCB, trips when too much current flows. That points to an overload or a short circuit on that circuit.
  • An RCD trips when it detects current leaking to earth, which is what happens if someone touches a live part. It may protect several circuits at once.
  • An RCBO does both jobs for a single circuit.

Knowing which one tripped tells you where to look.

Why tripping is more common in winter

  • Damp gets into outdoor lights, sockets and garden supplies, causing small leaks to earth
  • Heaters, tumble dryers and kettles are used more, and elements in older appliances often start to break down
  • Condensation in garages, sheds and outbuildings affects fittings and appliances kept there
  • Christmas lights and outdoor decorations, especially ones that have spent a year in the loft

Finding the culprit safely

  1. Switch off and unplug everything on the affected circuits. If you are not sure which circuits, unplug everything you can.
  2. Reset the tripped switch.
  3. If it stays on, plug appliances back in and switch them on one at a time, waiting a moment between each.
  4. When it trips again, the last appliance is the likely cause. Leave it unplugged and get it checked or replaced.

Do not hold a switch up to stop it tripping, tape it, or swap it for a bigger rating. Those devices are there to stop fires and electric shocks.

When it is probably the wiring

Call an electrician if:

  • The switch will not reset even with everything unplugged
  • It trips at random times with nothing obvious running
  • It trips when it rains, which often points to an outdoor fitting or a damaged cable
  • You notice a burning smell, scorch marks or a socket or switch that feels warm
  • A lighting circuit trips when you switch a particular light on

An electrician will test the insulation of each circuit to find where the leakage is, and check outside lights, garden sockets and any supplies to outbuildings.

When nothing has tripped

If a single appliance stops working but nothing in the consumer unit has tripped, check the fuse in its plug. A blown plug fuse often means the appliance has developed a fault, so replace it with the correct rating once and, if it blows again, stop using the appliance. If a whole circuit is dead and nothing has tripped, check the neighbours. It may be a supply problem, in which case call the network operator on 105.

What to tell the electrician

A few details make fault finding much quicker: which switch tripped, how often, what was running at the time, whether it happens in wet weather, and anything that has changed recently, such as new outdoor lights or building work.

Nuisance tripping on older boards

Boards with one or two RCDs protecting groups of circuits can trip because of small leaks from several appliances adding up, even when nothing is faulty on its own. When that happens, one trip can take out the fridge, freezer and half the lights at once. An RCBO board, with separate protection for each circuit, keeps a fault on one circuit from affecting the rest. Our consumer unit upgrade guide explains the options.

Tripping in older homes

Where tripping comes with other warning signs, such as old cable or scorched fittings, it may be time to look at the installation as a whole. Our guide on signs your house needs a rewire covers what to look for, and an EICR gives you a full picture.

Fault finding in Aylesford and Medway

We trace tripping faults, repair or replace damaged outdoor fittings and cables, and upgrade older boards to RCBO protection where it makes sense. See our domestic electrical and consumer unit service and our electrical testing service. We are based in Aylesford and cover Medway and the surrounding area. Call 01622 278762.

Common questions

Why does my RCD trip when it rains?

Water is usually getting into an outdoor light, socket or cable, causing current to leak to earth. An electrician can test and find the faulty part.

Is it safe to keep resetting a tripping switch?

Once or twice while you find a faulty appliance is fine. If it keeps tripping with everything unplugged, stop and call an electrician.

Will a new consumer unit stop the tripping?

Not if the cause is a fault. It can stop one fault taking out several circuits, and it makes faults easier to find.

Related

Get a free, no-obligation quote

Tell us what you need and we'll arrange a survey. No callout charge for quotations, and a fixed written price before any work starts.

Mon–Sat 7am–6pm · Based in Aylesford, Kent · Working UK-wide